TQ2416烧写出错了！
拿到手后，按教程，刷光盘带的sd启动，到SD上，启动，进不了uboot 界面切换回nandflash启动，无法启动。在secureCRT上无反应
用sd卡启动的显示如下：
U-Boot 1.3.4-svn10 (Aug 23 2011 - 02:04:51) for SMDK2416
CPU: S3C2416@400MHz
Fclk = 800MHz, Hclk = 133MHz, Pclk = 66MHz
Board: SMDK2416 DDR2
DRAM: 64 MB
Flash: 1 MB
NAND: SLC detected.256 MB
SD/MMC:1852 MB
After SD/MMC boot
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot:0
NAND erase: device 0 whole chip
Skipping bad block at0x05840000
Skipping bad block at0x05ca0000
Skipping bad block at0x08060000
Skipping bad block at0x096a0000
Skipping bad block at0x0cc00000
Skipping bad block at0x0d580000
Skipping bad block at0x0f560000
Erasing at 0xffe0000 -- 100% complete.
OK
reading u-boot.bin
** Unable to read "u-boot.bin" from mmc 0:1 **
NAND write: device 0 offset 0x0, size 0x100000
1048576 bytes written: OK
reading zimage
** Unable to read "zimage" from mmc 0:1 **
NAND write: device 0 offset 0x900000, size 0x300000
3145728 bytes written: OK
reading zimage_init
** Unable to read "zimage_init" from mmc 0:1 **
get_format
-------- 0 --------
Wrong Image Format for bootm command
ERROR: can't get kernel image!
SMDK2416 #0?俐 重新烧好了，要把光盘里的文件改名，这光盘制作的也太不用心了
页:
[1]