boot system 时出现这个，怎么回事?

0x000000200000-0x000000400000 : "EmbedSky_Board_kernel"
0x000000400000-0x00000ff80000 : "EmbedSky_Board_yaffs2"
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
usb usb1: New USB device found, idVendor=1d6b, idProduct=0001
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: S3C24XX OHCI
usb usb1: Manufacturer: Linux 2.6.30.4-EmbedSky ohci_hcd
usb usb1: SerialNumber: s3c24xx
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
usbserial: USB Serial Driver core
USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
pl2303: Prolific PL2303 USB to serial adaptor driver
s3c2410_udc: debugfs dir creation failed -19
s3c2440-usbgadget s3c2440-usbgadget: S3C2440: increasing FIFO to 128 bytes
mice: PS/2 mouse device common for all mice
TQ2440 TouchScreen successfully loaded
input: TQ2440 TouchScreen as /devices/virtual/input/input0
S3C24XX RTC, (c) 2004,2006 Simtec Electronics
s3c2410-rtc s3c2410-rtc: rtc disabled, re-enabling
s3c2410-rtc s3c2410-rtc: rtc core: registered s3c as rtc0
i2c /dev entries driver
Linux video capture interface: v2.00
zc0301: V4L2 driver for ZC0301[P] Image Processor and Control Chip v1:1.10
usbcore: registered new interface driver zc0301
gspca: main v2.5.0 registered
usbcore: registered new interface driver zc3xx
zc3xx: registered
usbcore: registered new interface driver uvcvideo
USB Video Class driver (v0.1.0)
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
mapped channel 0 to 0
s3c2440-sdi s3c2440-sdi: powered down.
s3c2440-sdi s3c2440-sdi: initialisation done.
s3c2440-sdi s3c2440-sdi: powered down.
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.18a.
No device for DAI UDA134X
No device for DAI s3c24xx-i2s
S3C24XX_UDA134X SoC Audio driver
UDA134X SoC Audio Codec
asoc: UDA134X <-> s3c24xx-i2s mapping ok
ALSA device list:
  #0: S3C24XX_UDA134X (UDA134X)
TCP cubic registered
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
lib80211: common routines for IEEE802.11 drivers
s3c2410-rtc s3c2410-rtc: setting system clock to 2008-11-07 15:05:42 UTC (122607
0342)
yaffs: dev is 32505858 name is "mtdblock2"
yaffs: passed flags ""
…………………………

uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncorrecta
ble error : <3>uncorrectable error : <3>uncorrectable error : <3>uncorrectable e
rror : <3>uncorrectable error : <3>uncorrectable error : <3>uncorrectable error
: <3>uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <4>
**>> yaffs chunk 9472 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 12032 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <4>**>> yaffs chunk 13376 was not eras
ed
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 14144 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 14208 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 14528 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 14592 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 14784 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <4>**>> yaffs chunk 14848 was not eras
ed
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <4>**>> yaffs chunk 14912 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncorrecta
ble error : <3>uncorrectable error : <4>**>> yaffs chunk 14976 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncorrecta
ble error : <4>**>> yaffs chunk 15040 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 15168 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <4>**>> yaffs chunk 15488 was not eras
ed
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <3>uncorrectable error : <4>**>> yaffs
chunk 20864 was not erased
uncorrectable error : <3>uncorrectable error : <3>uncorrectable error : <3>uncor
rectable error : <3>uncorrectable error : <4>**>> yaffs chunk 25024 was not eras
ed
**>> yaffs write required 17 attempts
yaffs_read_super: isCheckpointed 0
VFS: Mounted root (yaffs filesystem) on device 31:2.
Freeing init memory: 180K
Warning: unable to open an initial console.
Failed to execute /linuxrc.  Attempting defaults...
Kernel panic - not syncing: No init found.  Try passing init= option to kernel.
Backtrace:
[<c0039fd4>] (dump_backtrace+0x0/0x10c) from [<c02b140c>] (dump_stack+0x18/0x1c)

r7:00000000 r6:c03bdda0 r5:c03bd760 r4:c0396248
[<c02b13f4>] (dump_stack+0x0/0x1c) from [<c02b145c>] (panic+0x4c/0x124)
[<c02b1410>] (panic+0x0/0x124) from [<c00354f0>] (init_post+0xec/0x178)
r3:00000000 r2:c3876e00 r1:c03f1000 r0:c033eefc
[<c0035404>] (init_post+0x0/0x178) from [<c000847c>] (kernel_init+0xcc/0xf4)
r5:c001d6b0 r4:c001da14
[<c00083b0>] (kernel_init+0x0/0xf4) from [<c004af30>] (do_exit+0x0/0x620)
r7:00000000 r6:00000000 r5:00000000 r4:00000000

你烧写的那几个文件？