TQ2440_TEST 从ADS移植到MDK，JLINK不能调试

TQ2440_TEST 从ADS移植到MDK，JLINK不能调试，程序可以在NANDFLASH运行，我是裸奔三部曲的方法用
SecureRT+dnw烧写程序的，调试报错

LINK ARM ERROR
This target device does not support all the defin edbreakpoints!
Please reduce the number of breakpoints and start again.

The following breakpoint combinations are supported.

When executing from volatile(RAM) memory:
一unlimited address breakpoints and one data access breakpoint
一two data access breakPoints

When executing from non一volatile(eg FLASH) memory:
一two address breakpoints
一two data access breakpoints
一one address breakpoint and one data access breakpoint