|
|
各位绿林高手，我这几天一直在为根文件系统困扰，下面是启动信息，请大哥们帮一下忙，给个解决办法。
关于这个错误我找过很多资料，提前说一下：linux内核中的EABI选项已经选上，可是还是不行呀。
U-Boot 2009.08 ( 5月 20 2010 - 16:41:34)
DRAM: 64 MB
Flash: 2 MB
NAND: NAND_ECC_NONE selected by board driver. This is not recommended !!
64 MiB
In: serial
Out: serial
Err: serial
Net: dm9000
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x50000, size 0x1f0000
2031616 bytes read: OK
## Booting kernel from Legacy Image at 32000000 ...
Image Name: linux-2.6.30.4
Created: 2010-05-21 14:16:34 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2000496 Bytes = 1.9 MB
Load Address: 30008000
Entry Point: 30008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux............................................................................................................................ done, booting the kernel.
Linux version 2.6.30.4-Niuben (root@localhost.localdomain) (gcc version 4.3.2 (Sourcery G++ Lite 2008q3-72) ) #1 Fri May 21 22:11:26 CST 2010
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=00007177
CPU: VIVT data cache, VIVT instruction cache
Machine: SMDK2440
Warning: bad configuration page, trying to continue
Memory policy: ECC disabled, Data cache writeback
CPU S3C2440A (id 0x32440001)
S3C24XX Clocks, (c) 2004 Simtec Electronics
S3C244X: core 296.352 MHz, memory 98.784 MHz, peripheral 49.392 MHz
CLOCK: Slow mode (2.116 MHz), fast, MPLL on, UPLL on
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
Kernel command line: noinitrd root=/dev/mtdblock3 init=/linuxrc console=ttySAC0 rootfstype=yaffs2
NR_IRQS:85
irq: clearing subpending status 00000002
PID hash table entries: 64 (order: 6, 256 bytes)
Console: colour dummy device 80x30
console [ttySAC0] enabled
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 16MB = 16MB total
Memory: 12136KB available (3492K code, 314K data, 124K init, 0K highmem)
Calibrating delay loop... 49.15 BogoMIPS (lpj=122880)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 724 bytes
NET: Registered protocol family 16
S3C Power Management, Copyright 2004 Simtec Electronics
S3C2440: Initialising architecture
S3C2440: IRQ Support
S3C24XX DMA Driver, (c) 2003-2004,2006 Simtec Electronics
DMA channel 0 at c1808000, irq 33
DMA channel 1 at c1808040, irq 34
DMA channel 2 at c1808080, irq 35
DMA channel 3 at c18080c0, irq 36
S3C244X: Clock Support, DVS off
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
s3c2440-i2c s3c2440-i2c: slave address 0x10
s3c2440-i2c s3c2440-i2c: bus frequency set to 96 KHz
s3c2440-i2c s3c2440-i2c: i2c-0: S3C I2C adapter
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
NET: Registered protocol family 1
NetWinder Floating Point Emulator V0.97 (extended precision)
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
ROMFS MTD (C) 2007 Red Hat, Inc.
fuse init (API version 7.11)
yaffs May 21 2010 21:59:32 Installing.
msgmni has been set to 23
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Console: switching to colour frame buffer device 30x40
fb0: s3c2410fb frame buffer device
lp: driver loaded but no devices found
ppdev: user-space parallel port driver
s3c2440-uart.0: tq2440_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2440
s3c2440-uart.1: tq2440_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2440
s3c2440-uart.2: tq2440_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2440
brd: module loaded
loop: module loaded
Uniform Multi-Platform E-IDE driver
ide-gd driver 1.18
ide-cd driver 5.00
Driver 'sd' needs updating - please use bus_type methods
dm9000 Ethernet Driver, V1.31
S3C24XX NAND Driver, (c) 2004 Simtec Electronics
s3c2440-nand s3c2440-nand: Tacls=1, 10ns Twrph0=3 30ns, Twrph1=1 10ns
NAND device: Manufacturer ID: 0xec, Chip ID: 0x76 (Samsung NAND 64MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 4 MTD partitions on "NAND 64MiB 3,3V 8-bit":
0x000000000000-0x000000030000 : "My2440 boot"
0x000000030000-0x000000050000 : "My2440 param"
0x000000050000-0x000000250000 : "My2440 kernel"
0x000000250000-0x000003ffc000 : "My2440 filesystem"
usbmon: debugfs is not available
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usbcore: registered new interface driver libusual
usbcore: registered new interface driver usbserial
USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
usbserial: USB Serial Driver core
USB Serial support registered for FTDI USB Serial Device
usbcore: registered new interface driver ftdi_sio
ftdi_sio: v1.4.3:USB FTDI Serial Converters Driver
USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
pl2303: Prolific PL2303 USB to serial adaptor driver
mice: PS/2 mouse device common for all mice
S3C24XX RTC, (c) 2004,2006 Simtec Electronics
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
Advanced Linux Sound Architecture Driver Version 1.0.20.
ALSA device list:
No soundcards found.
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
yaffs: dev is 32505859 name is "mtdblock3"
yaffs: passed flags ""
yaffs: Attempting MTD mount on 31.3, "mtdblock3"
yaffs: auto selecting yaffs1
yaffs tragedy: attempting to use non-directory as a directory in scan. Put in lost+found.
yaffs tragedy: attempting to use non-directory as a directory in scan. Put in lost+found.
yaffs tragedy: attempting to use non-directory as a directory in scan. Put in lost+found.
yaffs tragedy: attempting to use non-directory as a directory in scan. Put in lost+found.
yaffs tragedy: attempting to use non-directory as a directory in scan. Put in lost+found.
yaffs_read_super: isCheckpointed 0
VFS: Mounted root (yaffs2 filesystem) readonly on device 31:3.
Freeing init memory: 124K
Kernel panic - not syncing: Attempted to kill init!
[<c002d740>] (unwind_backtrace+0x0/0xdc) from [<c02a41a4>] (panic+0x40/0x110)
[<c02a41a4>] (panic+0x40/0x110) from [<c004a944>] (do_exit+0x64/0x578)
[<c004a944>] (do_exit+0x64/0x578) from [<c004aee0>] (do_group_exit+0x88/0xbc)
[<c004aee0>] (do_group_exit+0x88/0xbc) from [<c0053dfc>] (get_signal_to_deliver+0x2ec/0x324)
[<c0053dfc>] (get_signal_to_deliver+0x2ec/0x324) from [<c002a464>] (do_signal+0x68/0x4e8)
[<c002a464>] (do_signal+0x68/0x4e8) from [<c0027dac>] (work_pending+0x1c/0x20) |
|
/1 
IP卡
狗仔卡
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
