问题:1、我只是想使用NFS的传输功能,并不想让板子的文件系统从PC上通过网线启动,不知如何操作?
2、我想配置uboot参数该如何操作?
每次在uboot按空格后,[1] Set NFS boot parameter -》输入nfs提示的相关参数,pc的IP:192.168.1.114,arm的ip:192.168.1.115,以及启动的:/linuxrc,255.255.255.0后,他就直接让arm的文件系统启动挂载到pc上了,如果没插网线,系循环启动,其实:Initializingnetwork drop monitor service dm9000dm9000: eth0: link down ADDRCONF(NETDEV_UP):eth0: link is not ready
一般其他公司的开发板都会允许用户自己配置uboot信息,TQ2440也是有的,但TQ6410除了菜单命令可以使用外根本不允许用户自己配置uboot参数,很是无奈,希望帮忙解决问题。
uboot只有这些可以操作????
##### Boot for SKY6410/TQ6410 Main Menu#####
##### EmbedSky USB download mode #####
[1] Download u-boot or STEPLDR.nb1 or other bootloader to Nand Flash
[2] Download Eboot (eboot.nb0) to Nand Flash
[3] Download Linux Kernel (zImage.bin) to Nand Flash
[4] Download LOGO Picture (logo.bin) to Nand Flash
[5] Download UBIFS image (root.ubi) to Nand Flash
[6] Download YAFFS image (root.bin) to Nand Flash
[7] Download Program to SDRAM and Run it
[8] Boot the system
[9] Format the Nand Flash
[0] Set the boot parameters
[a] Download User Program
[n] Enter TFTP download mode menu
[r] Reboot u-boot
[t] Test Linux Image (zImage)
|