|
大家好, 我用sd按照用户手册来烧写系统, 发现烧写后, 启动起不来了, 一下是烧写的打印信息, 请天嵌的人员帮我看下, 谢谢了
- ##### EmbedSky BIOS for SKY210/TQ210 #####
- This Board: SDRAM is 1024MB; LCD display size is: 800X480
- Hit any key to stop autoboot: 0
- SD and FAT initialize success!
- file length is 0x368.
- condition=INSTALL
- OSType=ANDROID
- beep state=ON
- bootloader=images\bootloader\uboot_TQ210_1.3.4_V1.6.bin
- file length is 0x6c000.
- NAND erase: device 0 offset 0x0, size 0x100000
- Erasing at 0xe0000 -- 100% complete.
- OK
- NAND write: device 0 offset 0x0, size 0x1b000
- Main area read (1 blocks):
- Checksum is calculated.
- Main area write (1 blocks):
- 131072 bytes written: OK
- logodir=images\logo\logo_800x480.bin
- file length is 0x177000.
- NAND erase: device 0 offset 0x200000, size 0x300000
- Erasing at 0x4e0000 -- 100% complete.
- OK
- NAND write: device 0 offset 0x200000, size 0x5e000
- Writing data at 0x25d800 -- 100% complete.
- 385024 bytes written: OK
- Android zImage=images\android\zImage_Kernel_3.0.8_TQ210_for_Android_v2.1_CoreB_20140410.bin
- file length is 0x4d6ea4.
- NAND erase: device 0 offset 0x500000, size 0x500000
- Erasing at 0x9e0000 -- 100% complete.
- OK
- NAND write: device 0 offset 0x500000, size 0x136000
- Writing data at 0x635800 -- 100% complete.
- 1269760 bytes written: OK
- Android rootfs=images\android\rootfs_TQ210_Android_4.0.4_V1.4_20140321.bin
- NAND erase: device 0 offset 0xa00000, size 0x3f600000
- Skipping bad block at 0x1cb80000
- Skipping bad block at 0x1cbc0000
- Erasing at 0x3ffe0000 -- 100% complete.
- OK
- NAND write: device 0 offset 0xa00000
- Writing data at 0xa3a2800 -- 100% complete.
- 166134144 bytes written: OK
- Saving Environment to NAND...
- Erasing Nand...
- Erasing at 0x100000 -- 100% complete.
- Writing to Nand... done
- NAND read: device 0 offset 0x500000, size 0x500000
- 5242880 bytes read: OK
- Boot with zImage
- Starting kernel ..
复制代码 |
|