|
求助,使用SD卡自动更新的方式刷Linux,刷机成功后系统无法启动,
串口log如下:
##### EmbedSky BIOS for SKY210/TQ210 #####
This Board: SDRAM is 1024MB; LCD display size is: 800X480
Hit any key to stop autoboot: 0
SD and FAT initialize success!
file length is 0x17f.
LineCount=15
condition=INSTALL
OSType=LINUX
beep state=ON
bootloader=images\uboot_TQ210_1.3.4_V1.6.bin
file length is 0x6c000.
NAND erase: device 0 offset 0x0, size 0x100000
Erasing at 0xe0000 -- 100% complete.
OK
NAND write: device 0 offset 0x0, size 0x1b000
Main area read (1 blocks):
Checksum is calculated.
Main area write (1 blocks):
131072 bytes written: OK
logodir=images\logo_800x480.bin
file length is 0x177000.
NAND erase: device 0 offset 0x200000, size 0x300000
Erasing at 0x4e0000 -- 100% complete.
OK
NAND write: device 0 offset 0x200000, size 0x5e000
Writing data at 0x25d800 -- 100% complete.
385024 bytes written: OK
Linux zImage=images\zImage_Kernel_2.6.35.7_TQ210_for_Linux_v1.4_CoreB.bin
file length is 0x4a7d3c.
NAND erase: device 0 offset 0x500000, size 0x500000
Erasing at 0x9e0000 -- 100% complete.
OK
NAND write: device 0 offset 0x500000, size 0x12a000
Writing data at 0x629800 -- 100% complete.
1220608 bytes written: OK
Linux rootfs=images\rootfs_linux_v1.4_CoreB.bin
NAND erase: device 0 offset 0xa00000, size 0x3f600000
Erasing at 0x3ffe0000 -- 100% complete.
OK
NAND write: device 0 offset 0xa00000
Writing data at 0x6d8c800 -- 100% complete.
107648640 bytes written: OK
Saving Environment to NAND...
Erasing Nand...
Erasing at 0x100000 -- 100% complete.
Writing to Nand... done
Start Linux ......
NAND read: device 0 offset 0x500000, size 0x500000
5242880 bytes read: OK
Boot with zImage
Starting kernel ...
请版主和高手们支持下,谢谢
|
|